North East F-Body Association
Page 11 of 20 « First 910 11 1213 Last »
Show 40 post(s) from this thread on one page

North East F-Body Association (http://www.northeastf-bodyassn.com/index.php)
-   Project Logs (http://www.northeastf-bodyassn.com/forumdisplay.php?f=34)
-   -   Red Rocket under knife (http://www.northeastf-bodyassn.com/showthread.php?t=121)

ILuvPizzaTimes10 11-28-2009 08:30 AM
Ohh hes gunna be in there with a cut off wheel!!!!!! any elbow worth a damn wont fit under there with out some cutting. Hence why i might not go Carb intake. LOOKIN AWESOME DON!!!! cant wait to line up with you wen i get my 300 Shot!!!! BAHAHAHA

sciff5 11-28-2009 09:00 AM
Quote:
Originally Posted by Slowhawk (Post 5249)
Engine is in.Tranny went in and now has to come out. WTF. Stupid hardened output shaft splines are too tight to my driveshaft!!!! Tranny's going back to have the shaft redone...FUCK.....

Would of been running by mid next week...
I think this is the first time I've see don get excited about any car.

I dont know if you'd be able to find any traction on these cold roads even if you did get it on the road in the next couple weeks. Sure would be fun trying though.

Slowhawk 11-30-2009 02:35 PM
2 Attachment(s)
Quote:
Originally Posted by sciff5 (Post 5298)
I think this is the first time I've see don get excited about any car.

I dont know if you'd be able to find any traction on these cold roads even if you did get it on the road in the next couple weeks. Sure would be fun trying though.
I get more ticked off when shit isn't right.My cars are always problems.Here are some picks with the elbow.Fit alot better than I thought it would.

Batman 11-30-2009 04:21 PM
does the hood close or are you going to get a different one

ILuvPizzaTimes10 11-30-2009 04:24 PM
i was just thinking the same thing. i doubt it will even with a ram air hood. but i bet a cowl hood could be trimmed up and fit right on?

Slowhawk 11-30-2009 04:34 PM
Ram Air hood will fit no problem. I'll cut my shitty hood for clearance.After I'll have a cowl put on.

Formula413 11-30-2009 09:38 PM
Quote:
Originally Posted by Slowhawk (Post 5441)
I get more ticked off when shit isn't right.My cars are always problems.Here are some picks with the elbow.Fit alot better than I thought it would.
That does fit pretty nice, I thought you were gunna have to go crazy with the sawzall to fit it. Just a little chunk out of the cowl, not bad at all.

Slowhawk 12-08-2009 04:47 PM
1 Attachment(s)
My new throttle body against an old 90mm throttle body.

ILuvPizzaTimes10 12-08-2009 05:05 PM
Holly Shit!!!!!!! what is that one on the left?

ls6monte 12-08-2009 05:26 PM
Just a little bit bigger! Sweet!


All times are GMT. The time now is 09:04 AM.
Page 11 of 20 « First 910 11 1213 Last »
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.