102 swap Finally tuned.

[Bayer-Z28]

PREVIOUS numbers were at TSP - 414/372 with the same cam and heads, stock pump and injectors MAF tune.

So it's been a while. I had them fix a bunch of other stuff too. Mice ate through a harness on top of the tank, they found a HUGE rats nest. Had 4 codes that they diag'd, one was for the fuel tank pressure sensor or something. Also had a lazy O2 sensor (I supplied), and the fuel pump was running out of room. Also, had them fix my crushed Y-pipe that I beat the fuk out of a couple years ago. And it needed a new belt tensioner. -was throwing belts now.

So long story short, here's the rundown..... Sorry, no videos yet. I wasn't 100% satisfied with these guys that tuned it. THEY took the videos and now the owner has them, and I ASKED for an a/f graph, they didn't supply it and i TOLD him that I asked for it on MONDAY. -No excuse for that. They also didn't order my Racetronix255 pump and harness from the vendor I specified ($209) so they tried to charge me $250 for it and they ate the difference when I told them what was up.


Ok... ok... Enough of my yammering.....




Who was it again that said I would lose low end?? Who said the intake was too big??? Hmmmmm.....



Ported 243 heads
TR/PatG cam 224/228 .637.639 110
FAST 102 with some minor smoothing.
NW 102 TB
SD tune
42# LS1 injectors
Ractronics 255 pump with hotwire fix
FTP 98mm lid.
SLP headers
SLP SLP ORY
TSP Rumbler CB
ASP UDP



456/424rw. They stuck some stock mufflers on the tips because they said it was too loud.. Anyway.. They said that may have been a 5hp loss because they were some stock mustang mufflers that are pretty restrictive. I'll get some new numbers some time this summer.


I showed PatG the numbers. He was quite impressed! he made 460/440 with this cam, but on his ideal setup.

Not bad for stock-ish heads and shitty SLP LT's, but those are tuned length headers meant for low to mid range power. That's prolly why the TQ shoots way up early. he said he set it for a commanded AFR of 11.7, so I don't think it's above 12.




-=EDIT=-

I've got an issue with these dyno sheets. These are the EXACT SAME one as they showed me last time I was in there. Gonna go back tomorrow. I'm not going back there again, otherwise. I'm not impressed with their customer service. And the fact that they gave me an excuse when I asked for the a/f graph and said that "mike" has them on his computer when I called on MONDAY and asked for them to be in the dyno readouts.

They produced some good numbers for me, but they're EXPENSIVE and a pita to deal with. I wouldn't recommend them.