I wouldn't go with anything smaller then a cc305 but that is just me. Also if you are pulling the heads your probably just better off getting a lloyd elliot h/c setup and do it only once.
|
i agree with Jon. i would keep stock unported heads If your gunna have the time and money do it once. But didnt you also say you were doing an oil pump? Why? i wouldnt recomend doing any power adders like pp heads and cam if you having bottom end issues.
|
I am having oil pressure issues, it is dropping at high RPMs so I have a feeling the previous owner threw in a HV pump or possibly left out the baffle. If I had known about it when I had the pan off to do the timing set I would have done it then. As for asking about the cam, the reason I dont want to touch the heads is because Im a bit tight on cash right now, and it is my DD most of the year, so I just want to keep it somewhat simple (for now). If I could find a cheap, used H/C setup very soon, maybe that would change things, or if I find a cam that fits the bill. Otherwise, I have also been comtemplating just getting it running and 100% then a 150 shot in the spring, which is seeming more and more likely...
|
CC503 if u want to go cam only.
if not get a head cam package. oh and do the springs if u can. |
Well, the thing is, I dont think I can do springs...i need a cam that I can DEF keep the stock springs with...
|
if you are pulling the heads springs are tit ????
|
WITH ANY CAM WORTH DOING STOCK SPRINGS ARE NOT GOING TO CUT IT
|
Seriously boomer we need to get u hooked on phonix. The mix and match shit has to go.
|
Quote:
|
OK oil pressure dropping at high rpm Period OR high rpm under a load say full or close to full throttle? If thats the case its not your oil pump And like i had sed previous your main bearings have excessive wear possibly due to the blown head gasket?? Now a HV pump install can fix this BUT i would only do it for a temp fix and get a shortblock ready to go for next season or so.
As far as a cam goes. A i wouldnt do one IF your bottom end is weak. But if your dead set on it.... Get a CC304. everyone bashes it BUT 941LE has gone a best so far of 12.7 and he hasnt pulled a head OR changed a valve spring. Thats your best bet for a stock tune stock springs cam. there is not anyother cam on the market with the correct specs to keep stock springs. hope any of that helps. |
| All times are GMT. The time now is 11:36 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.