North East F-Body Association

North East F-Body Association (http://www.northeastf-bodyassn.com/index.php)
-   Fourth Generation (http://www.northeastf-bodyassn.com/forumdisplay.php?f=16)
-   -   started my cam/intake swap last night! (http://www.northeastf-bodyassn.com/showthread.php?t=2675)

ls6monte 04-18-2011 04:28 PM

Quote:

Originally Posted by Batman (Post 44395)
Make sure you do not re-use the old bolt for the pulley, good time to switch to a re-useable ARP bolt

Tell that to Don! lol


Looks good!

DemonWithin99 04-18-2011 05:32 PM

looks good, should have towed it to don for a real tune... ::tuner plug::

danZ28 04-18-2011 11:19 PM

Quote:

Originally Posted by DemonWithin99 (Post 44442)
looks good, should have towed it to don for a real tune... ::tuner plug::

I know. I wish I could have, but my little 4 banger daily driver ranger does not have the balls to tow the car. Hopefully the mail tune isn't too bad for the time being

Slowhawk 04-19-2011 12:20 AM

Alot of my customers get a mail tune to get to me. That cost goes towards there full tune bill.(if done at a reasonable timeline).

I hate mailorder tunes and won't send permanent ones.About 90% of the one's I see are dangerous and just hope the KR sensors work to save the motor.

danZ28 04-19-2011 12:46 AM

Quote:

Originally Posted by Slowhawk (Post 44464)
Alot of my customers get a mail tune to get to me. That cost goes towards there full tune bill.(if done at a reasonable timeline).

I hate mailorder tunes and won't send permanent ones.About 90% of the one's I see are dangerous and just hope the KR sensors work to save the motor.

I really wish I knew that last week when I sent my computer out. Damnit :(

Well, I got the new cam in today and the oil pump off. Lined up the crank and timing gear dots. A guy down the street from me who has done a lot of LS1 motor work said he'll check them for me before I put everything back together. Hopefully he's free tomorrow.

ILuvPizzaTimes10 04-19-2011 01:47 PM

check them? go dot dot. spin the motor 4 complete Crank revolutions and make sure they line back up. if your worried. Done

and id be willing to bet the ecu just got there and they havent gotten to it yet call em up and say DON TOUCH IT! and just pay the return shipping. then have a friend or use your AAA to get the car to bridegwater.

danZ28 04-19-2011 08:37 PM

#1 cylinder has to be at TDC when the dots are lined up, correct?

ILuvPizzaTimes10 04-20-2011 01:33 AM

si senior

smokinss 04-20-2011 12:02 PM

Looking good. You could of done the pen magnet method like I did to hold up the lifters. I got 16 retractable pen magnets and just slid them down the pushrod holes to hold up the lifters.

Formula413 04-20-2011 06:53 PM

Nice work, should be a solid setup when it's done and tuned. I'd like to see it when it's out and about, let me know if you want to meet up sometime. I'm down in Chicopee but my Formula is in Northampton.


All times are GMT. The time now is 03:16 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.