Kinda what I was thinking Don!
|
yeah they are very roughly cut which is what i believe lead to this happening.
|
It's not just the rough cut, it's the straight across the heads too.
That crack I doubt is from the head surfacing. It's probably a casting defect. I've seen stuff like that from Patriot before but not GM run stuff. |
Joe who did the milling again? LC?
|
Turns out head wasn't cracked. Also all the valves were leaking, can't believe it ran so good. Heads were also cut no where near as much as I had asked, so the compression wasn't much over stock.
|
failure
|
| All times are GMT. The time now is 01:38 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.