UPDATE... I HAVE A CLUTCH NOW!!!!!!!! Woo Hoo!!!!!



Yes Don. That is the clutch master I'm using. Can you tell me what is wrong with them? Everything in the system is new.

What was the problem with rpm issue you had.

The fuel cutoff got in the tune somehow from what Ron told me. Don took care of it in a few minutes. All better now.

The clutch is fine now. It was just a matter of bleeding it. We used the Phoenix system which pushes fluid and I had a clutch in 10 minutes after screwing with it for almost 3 weeks. Went to take it for a ride and the car wouldn't run past 2k. Like Justin said the fuel cutoff was at 2k. Don took care of that for me and I went for a ride the other night. Feels weird with the manual in the car.

Got most of the interior buttoned up last night. Have to fix a small header leak. I should have the new center section for the rear end in next week. Then it's a matter of cleaning the sled!


http://i187.photobucket.com/albums/x...psten7jwca.jpg

Got the sheetmetal made around the shifter. Lower boot installed.


http://i187.photobucket.com/albums/x...psergdlylh.jpg

Pedals installed a while ago. Got some wiring cleaned up under dash.

Looks awesome! Bet its a blast to drive now

it looks like a factory set of peddles, looks really good.

Still haven't really driven it yet. Trying to fix everything before I start driving. Only put 5 miles on it so far.

http://i187.photobucket.com/albums/x...psc2s9dmow.jpg

Tonight's crap disaster. :Oops: Getting this welded up tomorrow.

Hopefully this will be the last of it.

Must not seal very well lol

Frank, the pedals are an original set from a G Body.

Got the header fixed tonight and put back on the car.

http://i187.photobucket.com/albums/x...psasmnzknh.jpg

Got the shift boot and shift knob installed.


http://i187.photobucket.com/albums/x...ps1ftjff9k.jpg

Shift boot is a cheapie till I can figure out if I'm going to use the console or get something else. It will work in the meantime.

Hopefully tomorrow I can start to drive it. Woo Hoo!!!

Looks killer! Did these have the option for manual trannys from factory? If they did must have been a 5speed?

That thing looks awesome Ronnie!

Looks good with the factory console.

Nice! Now bring it down here so I can teach you to drive it!!!

Very nice! Looking good.

They did have that option but it was a 4 speed. I believe 80/81 was the last year.

Thanks everybody! I put about 60 miles on it today. So much fun!!!!

This was tonight's doing.

http://i187.photobucket.com/albums/x...pssr5f8kht.jpg

Picked up the new rear center section from my friend that ordered it for me. 31 spline axles, Detroit Trutrac with 4.11 gears. We got that installed tonight.

http://i187.photobucket.com/albums/x...ps9sydgflc.jpg

Please don't mind the red silicone. My friend likes to use it all the time.

Letting it set overnight. Will fill it up in the am and let the gears break in.

Hopefully will be done finally and can start to put miles on it this weekend.

Looks great ron. What did u have for gears before.

I had 3.70 gears before. The 4.11's should be fine for me.

Breaking in the new gears this am. Whenever the weather gets nice it will be out.

Car sounds so good.