well snow is comin down right now!

been a long time since ive been into this stuff but i bet you can buy or atleast figure out a way to run beehive springs on a old sbc now a days.

i bet a more efficient fuel injector would help a little to.

yea its snowin but not enough around here haha

ill research it a bit and see what i can find for options before i make any deffinate decisions

does anyone know if i have roller lifters? i had a lifter out before but i forget if it was roller or not.

center bolts?

no

prob not then but block might have the spot for the spider.

yeah usually they have the boss for it but they are not drilled and tapped. its simple to do really just keep a shop vac handy and dont let the fillings deep in the motor and you can do it.

so i take it you guys are talkin about this...
http://www.thirdgen.org/techboard/te...ry-roller.html


so basically is what i would need is cam, lifters, pushrods, and timing chain. right? plus drill and tap possibly?