Quote:
|
I think thats the one in the car joe
|
lightend 4.30s on the way, going bullet proof strange pro iron nodular case & nodular daytona support. im not doing this a third time!
|
decided to go with the strange n1917 billet aluminum daytona support, pricey little fucker but after talking to strange its stronger than the nodular daytona support. also needed a new pinion yoke, my long yoke wont work with a daytona support so i ordered a billet aluminum 1350 short yoke. figured if i was going to start from scratch to do it right. the lightened gear set and aluminum yoke will save 4lbs of rotating weight, would be nice to see a gain from it but it certaintly wont hurt anyway.
now just need to sell some more shit on ebay and save for a case and install kit. |
Only thing I can see is why the aluminum yoke? Different expansions of the metals could cause a spline roll under heat and high loads. Aren't the aluminum yokes for circle track?
|
they offer them for drag racing. its a forged billet aluminum yoke, not cast.
|
ohh well thats good. i got a billet steel for mine. only thing aluminum about mine is the billet aluminum pinion support like yours. either way a strong setup for sure! good luck. i still have a spool!!!!!!! :)
|
I think joes locker was the only thing that was OK in that mess
|
yeah the truetrac is fine
|
Yeah I've got the S case for mine with the pinion support. Takes 6k clutch dumps all day long.
|
| All times are GMT. The time now is 11:43 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.