North East F-Body Association

North East F-Body Association (http://www.northeastf-bodyassn.com/index.php)
-   Project Logs (http://www.northeastf-bodyassn.com/forumdisplay.php?f=34)
-   -   T 56 swap in my G Body (http://www.northeastf-bodyassn.com/showthread.php?t=5377)

ls6monte 04-19-2014 05:26 PM

UPDATE... I HAVE A CLUTCH NOW!!!!!!!! Woo Hoo!!!!!



Yes Don. That is the clutch master I'm using. Can you tell me what is wrong with them? Everything in the system is new.

frankzlt1 04-25-2014 12:35 AM

What was the problem with rpm issue you had.

smokinss 04-25-2014 02:50 PM

The fuel cutoff got in the tune somehow from what Ron told me. Don took care of it in a few minutes. All better now.

ls6monte 04-25-2014 04:33 PM

The clutch is fine now. It was just a matter of bleeding it. We used the Phoenix system which pushes fluid and I had a clutch in 10 minutes after screwing with it for almost 3 weeks. Went to take it for a ride and the car wouldn't run past 2k. Like Justin said the fuel cutoff was at 2k. Don took care of that for me and I went for a ride the other night. Feels weird with the manual in the car.

Got most of the interior buttoned up last night. Have to fix a small header leak. I should have the new center section for the rear end in next week. Then it's a matter of cleaning the sled!


http://i187.photobucket.com/albums/x...psten7jwca.jpg

Got the sheetmetal made around the shifter. Lower boot installed.


http://i187.photobucket.com/albums/x...psergdlylh.jpg

Pedals installed a while ago. Got some wiring cleaned up under dash.

ZFreie 04-25-2014 05:17 PM

Looks awesome! Bet its a blast to drive now

frankzlt1 04-25-2014 09:50 PM

it looks like a factory set of peddles, looks really good.

ls6monte 04-26-2014 02:36 AM

Quote:

Originally Posted by ZFreie (Post 86456)
Looks awesome! Bet its a blast to drive now

Still haven't really driven it yet. Trying to fix everything before I start driving. Only put 5 miles on it so far.

http://i187.photobucket.com/albums/x...psc2s9dmow.jpg

Tonight's crap disaster. :Oops: Getting this welded up tomorrow.

Hopefully this will be the last of it.

ZFreie 04-26-2014 01:57 PM

Must not seal very well lol

ls6monte 04-27-2014 03:12 AM

Frank, the pedals are an original set from a G Body.

Got the header fixed tonight and put back on the car.

http://i187.photobucket.com/albums/x...psasmnzknh.jpg

Got the shift boot and shift knob installed.


http://i187.photobucket.com/albums/x...ps1ftjff9k.jpg

Shift boot is a cheapie till I can figure out if I'm going to use the console or get something else. It will work in the meantime.

Hopefully tomorrow I can start to drive it. Woo Hoo!!!

ZFreie 04-27-2014 09:23 AM

Looks killer! Did these have the option for manual trannys from factory? If they did must have been a 5speed?


All times are GMT. The time now is 02:29 AM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.