12.812 @ 107.99 1.840 60 ft with the 9" and 4.10s 1900 DA

Very nice Joe!

Nice work!

Awesome job Joe. I HOPING. FOR GOOD. RESULTS. WITH. ET STREET SLICK

Itll go faster! im leaving alot on the table with that 60' too!

good luck jay, its HOTTTTTttt up here

12.72 @ 107.67 1.78 60' 900' DA

Getting better Joe!!!!!!!!!!!!

Boomer don't you have a faster time than the one listed?

12.14 @115.2mph. 1.84 60ft i can smell 11's!! Think the stock 10 /342s can do it? I don't!

get your 60 foot down to a 1.74 and everything else being equal you will cut almost 2 tenth off your ET.

It will pretty much come down to whether the 10 bolt will hold the lower 60' time needed. What tires are you on? And what RPM are you launching at?

If i got it down to a 74 i'd cut more than 2 tenths off i bet. I cut 2 tenths off when i went from a 1.95 to a 1.89 But it doesnt seem possible on these stock gears and rear

Oh trust me i know haha i have a spare rear sitting just in case to get me by till the 9", i'm running M/T drag radials 16". I am not dumping the clutch just letting it out hard. this is the video of the 12.3 dont have the 12.1 launch but pretty much the same.

http://youtu.be/1mop6Upf7VA

i sed if everything else was equal. if you cut time off during your shifts as well then your et goes down. its all seat time. the stock 10 bolt can hold up if you launch it right. your gunn have to hit the tires a little harder to cut down on the 60 foot. i tryd hitting the clutch harder and ran 3 tenths slower then wen i dumped it. But dumping it at the rpm needed to cut a better 60 foot and your in the realm of a dead 10 bolt. and like he sed what tires are you on? my best times yet were wen i had just a LITTLE bit of spin out of the hole. meant i didnt bog. are you bogging at all?

My run I posed with thw youtube link I spun the tires a little not much though. Your right if you launch it correctly and not just dump it the rear may hold up longer. I'm going hardrler and harder till it snaps haha

your going to need a little tire spin to keep the rpms up with those gears.

True i dont know if i can get the 11's but i'll try like hell.

12.719 @ 107.89 1.783 60 ft tonight

How was the da last night?

decent, 1100 at the beginning and 800 by the end

12.7 @ 110 2.0 60ft

Nice

The 3.73s finally delivered, nice. Bet it's got another tenth in it with cooler air.

its got more in it, the shift points are wrong.

Nice Maddie!

Thats a decent MPH you will be low 12's with that and an auto

11.6 @ 117 still has a few more tenths in it. I will be going to the track as soon as my car get out of the body shop. new paint job

welcome to the show. you should make an intro thread tell us a little about the car!!!

New PB 1.828 60' 8.176 @ 85.96 12.708 @ 109.05 3660lbs DA 1038

Getting there Joe!

October -300 air and you will see low 12's!!

i know right, the air is coming but i dont want to rely on the air to go quicker, i gotta get this car to 60' before it gets cold so i can see what it does with a normal DA. 6 speeds suck.

would have hit a 12.6x last night on this run but i mis shifted 4th and went to 6th

.090 1.850 5.303 8.158 @ 86.17 fastest 1/8th mile ET of the night and fastest 1/8th mile mph for this car. better luck next time.

best 60' of the night was 1.78 but of course i missed 2nd and gave up on the run.

11.618@19.98mph with a 1.70 60 foot leaving wheels up with a slight spin causing the car to shift over like 18 inches it was the weirdest launch I have ever had

11.61 is a great time though. I had a best of 12.07 @115 w a 1.68 60ft I am getting this damn 11 with stock heads if it kills me! haha

1.878 60' (spinning bad) 8.063 @ 86.81 12.546 @ 109.31 totally smashed my 12.6 goal to bits! -43DA

nice!!

11.80@114.03

Updated, nice runs

update it right douche! 4.30s! frikken LT1 owners i tell ya!