MY LS brake swap
 

well if it went off with out any promblems I would just showed up and had pics but the parts god does not like me . :gripe::gripe:

story goes like this ok i get both spindal and calipers off a 1998 Camaro 75.00 , good deal ok check out claipers ,bleeders screws good , paint caliper nice, painted spindal .:tapfoot:

Get all parts like hunting down brake line washers ,brake hard wear kit. Wrong get them on frigging banjo bolt stripps out caliper now junk , now i have to buy calipers ,man it came with all that stuff -man so pissed , should of just got new calipers from the get-go lesson leard , advice to any one think off doing the swap.
,driver's side .now the upper control arm bushing's driver's side wiped out great . Just aggravating so much for a simple job. now sawpping out bushings:sFun_bananacolors::sFun_bananacolors:



aaaaaaahhhhhhhhhhhhhh:fu::sFi_punch::gripe::gripe: :gripe::gripe::shiftyeyes::shiftyeyes:

funny u posted this i was thinking of doing the ls brake swap on my car in the summer let me now how they feel once you get them all put together and drive on them for a few miles. hope it goes together smooth from here on out. haha

Eh at least now you know for any future ideas. Still a bummer though. Sorry to hear that man.

i told you to run the LS1 Banjo Bolts! and never trust used calipers unless they come from a trusted source.

thanks mike,:asshole::asshole::asshole::asshole:

i did use LS banjo bolts putting it back together hahahaha sure thing ben

-.-

Hey you let them SIT without being capped for MONTHS! thats your boo boo

well thanks mike no really they were cap just my shit luck new ones were like 52$ minus the core
thanks for the heads up mike and help mike befor i started :BFing::tard::tard::tard:

Jay i was reffering to Klab the post above me. he bought a break swap off my firebird. and left them open and got mad they seized up........

Ok but thanks for help

whaaaaaaat they didn't sieze uppppppppp they were just ugly as shit and they were stuck till i pushed the pistons in :D

ok kevin as long as they dont leak and get stuck i just got reman clipers 52$ each safe than sorry ,
also finished control arm bushing and changed upper ball joint already in there might as well .:ahhhhhhh::reaction::nopity:

well aint that pretty!

lookin good buddy boy!!!! NOW LETS RACE!!!!

Looks good.now I want to up grade mine now so I can race pizza and beat him lolool

well its gunna cost me an extra 200 i wasnt expecting. SO tires are out of the question might do the drive shaft and thats it.

COME OOOONNNNNNNNN:sFi_punch: :sFi_punch::gripe::gripe::gripe::gripe:
you need tire,s

Ok job done I'll try to get pic. On and Ben I have to burnish the pads I will say better brake pedal :yaaaay::yaaaay: