Yay, more stuff to fix!
Ok now since the weather is starting to get better my car doesn't want to run like it did this winter. It's almost acting like it was earlier last year before Don rewired the fp relay.
Have noticed a few things that happens when it seems to start acting up. The main one is temperature related,only happens when the ambient temp is greater than 60 or so degrees out. Car doesn't act up in the mornings just yet. Not sure if it is voltage related, but again, in the mornings the car will run about 14.2 volts, and for some crazy reason, afternoons when it's warmer out, only runs to about 13.4v or so volts(didn't put a dvm on it just eyeballed it according to the gauge). While the car is chugging, the oil pressure drops to 30-35psi and starts acting relative to engine load (higher rpm and pressure comes back up). It almost seems like a pretty bad miss, or vac leak. rough idle, hesitation and almost completely unresponsive throttle at times when it gets pretty bad. It only does this on idle, so leads me to believe it could be a few things related to it. A) Vacuum leak - maybe somewhere in the PVC line system or manifold related B) IAC or TPS - only does it when the car has ran for about an hour after driving home from work. Doesn't act up in the mornings when it's cooler. Also had a P0171 code show up the other day, I think it's just because I was trying to get it home. Cleared the code, but had another one pending today as well that didn't trigger the mil lamp. Below is the list of the readings from my scanner when the mil triggered yesterday: TROUB CODE P0171 ABSLT TPS(%) 0.4 ENG SPEED(RPM) 896 CALC LOAD(%). 2.7 MAF(LB/M). 1.02 MAP("HG). 8.6 COOLANT TEMP(F) 174 ST FTRM1(%). 6.3 LT FTRM1 (%). 24.2 ST FTRM2(%). 9.4 LT FTRM2(%). 24.2 VEH SPEED(MPH). 4 FUEL SYS 1. CLSD FUEL SYS 2. CLSD Anybody want to chime in? And Don if you get to read this, got some free time to play with my car again? |
Its the opti...jk I have no idea
|
Lol, wish it was that simple.
Noticed the lean bank 1 code came back yesterday while I was viewing data while the car was acting up. For some reason o2 data isn't saved in the freeze when the mil is triggered. But not showing p0174, makes me wonder if it is real or maybe a leaking intake on the drivers side. |
Ok, after some digging around today while sitting in front of the house I noticed something that might help diagnose it. Short term fuel trims steadily rise while the car starts to chug and spike up past the lt fuel trims, >24.2.
Took a video of it and attached it below... |
probably a bad o2 sensor.
|
Did you check to see if one bank has fouled the plugs?
|
Both of the 02's are lean. Could be a major vacuum leak, bad mass air meter.
Of course we can check it out for you. Should be a simple fix. |
Are you going to be around Saturday, Don? Maybe I can swing by if you're available. I did manage to get a video from the front of the car near the airbox where it's ported and when giving it some throttle, you can definitely hear it sucking in air. Not sure if it's from a big vacuum leak, or just the normal air intake from the tb, but it is pretty loud.
Will see if I can get the video posted here a bit later on today. |
I was there 12-4 today.
You work close to here. Lunch break? |
Yup, kind of. I am in the industrial park off 495 behind the Holiday Inn off Bay Street. Maybe 10 mins away at the most with traffic.
If you're around on Monday let me know, will give the shop a call in the morning around 10 or so. I'll be at work and might just take an extended lunch break. |
just stop in!!!!!!
|
Was thinking if it was the intake manifold, I got this Lingenfelter just sitting around collecting dust from the previous owner who never got around to installing it. Only bad thing is that the retard couldn't find any of the hardware or the gaskets and access cover for the bottom of it. So would have to get the gaskets and either modify the coolant tubes, or get some ls6 ones.
Been trying to find some flow charts for a comparison between the Weiand/Lingenfelter 300-111 and the stock LS1 intake and haven't had much luck. Guessing the numbers aren't that far out enough for them to really show off what the intake will do over the stock one? I have heard numbers as high as 25 extra ponies. Have also done a lot of reading based on the heatsoak over time vs the stock plastic one blah blah blah. Not sure that I put that much stock into the heatsoak theories because the car won't be sitting and idling in traffic much at all and I probably won't be doing any 1/4 runs here anytime soon. |
I put one on my ss. I picked it up for cheep. I didn't really notice much over my ls6 intake. If you get the felpro gaskets just make sure they are lined up right or you will have a vaccum leak.
|
Im willing to bet its so rich its stalling the car out. doubt its a vaccum leak
|
Only does it while idling after it's warmed up in the afternoons, when ambient temp is 60+ out. Or at least so I have noticed. Have also noticed that it does run on the rich side pretty much anytime, but getting good readings from the front o2's. both seem to run around .030 and .065 v respectively. But the short term fuel trims seem to be telling me otherwise. Not sure if it's trying to overcompensate for a vacuum leak, henceforth the st ft's spiking like that under idle.
Got me stumped for sure right now, but at least got the car washed and a fresh coat of Meguiar's on her this weekend. |
O2 volts are a funny thing. narrow bands suck. when they are to rich I.E. wet fuel/soot on them they read lean(low volts). and the pcm picks it up as LEAN and adds more fuel compounding the problem. bet you have a K&N filter? cleaned the MAF?
|
Paper filter, k&n is too oily for my tastes and have heard horror stories of them coating the MAF. Just cleaned the MAF like a month ago anyways, just to be sure also cleaned the iat as well.
|
| All times are GMT. The time now is 07:20 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.