North East F-Body Association

North East F-Body Association (http://www.northeastf-bodyassn.com/index.php)
-   Cars-Parts F/S WTB (http://www.northeastf-bodyassn.com/forumdisplay.php?f=19)
-   -   GI: 2002 Tahoe Z71 (http://www.northeastf-bodyassn.com/showthread.php?t=2452)

Batman 03-08-2011 03:35 AM

2002 Tahoe Z71
 
Still haven't been able to get a decent job up here so thinking of selling the Tahoe. I just put about $4500 worth of work into it but as much as I drive the gas is wiping out whatever paycheck I get. Anyway basic info below:

2002 Chevy Tahoe Z71
120xxx miles (tons of highway driving)
Never been hit, some small dents and dings and a few scratches, give the paint a 7 out of 10, maybe 8
5.3 Flex fuel engine (gets about 14MPG around town, 17 Highway)

What's New (within 2500Miles)
-Left front axle
-All 4 wheel bearings
-Replaced C clips in rear axle
-All 4 calipers
-All 4 rotors and pads
-rear brake backing plates
-New Transfer case (aftermarket reinforced)
-New front driveshaft
-New rear U joints
-New front sway bar
-new endlinks
-new sway bar bushings
-All 4 window motors (passenger front is still slow)
-both rear window regulators
-Rear blower A/C blower motor
-Front A/C resistor pack

Tires are about 5 months old, one wheel has been replaced (due to a puncture from the old rear caliper bolt breaking)
Mods
-Edelbrock IAS monotube shocks
-Replaced rear springs with stock GM Z71 springs at 105K
-P&P throttle body with spacer
-Coil packs have 25K on them
-Plugs and wires 6 months ago (E3 plugs, GMPP wires)

The bad
-1 side step is scraped and bent from when the concrete block fell off a truck in front of me a little work with a hammer and some paint and it'll be good as new.
-Brake lines should be replaced, they are rusty, I've been waiting to see if GM pushes the recall or not but I can show you where you can get stainless lines for about $300
-truck has a sticky lifter that makes some noise on a cold start, goes away after about 15 seconds. It's been that way since I got it with 30K on it.

Also included will be a set of SS caliper lines and a full set of PST polygraphite rear control arm bushings.

I'll get some pics for people interested once I de-louse it from winter.
Asking $7000.00

http://i36.photobucket.com/albums/e2...m/DSCN0228.jpg
http://i36.photobucket.com/albums/e2...m/DSCN0229.jpg
http://i36.photobucket.com/albums/e2...m/DSCN0230.jpg
http://i36.photobucket.com/albums/e2...m/DSCN0231.jpg

Batman 03-17-2011 10:11 PM

Pics posted, price drop, dealer offered me $7000.00, match it and it's yours

DemonWithin99 03-18-2011 06:42 AM

If it wasn't an SUV I'd say throw a short block in the back and I'll be there next wed. but my next DD will be a small 4dr truck.


All times are GMT. The time now is 01:05 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.