North East F-Body Association

North East F-Body Association (http://www.northeastf-bodyassn.com/index.php)
-   LT1/TPI/TBI (http://www.northeastf-bodyassn.com/forumdisplay.php?f=36)
-   -   adjusting rockers (http://www.northeastf-bodyassn.com/showthread.php?t=2695)

black heartbeat 04-21-2011 08:57 PM

adjusting rockers
 
So because there was a clacking in my valvetrain last year that got progressively worse and i blew my rear end just before i had a chance to address it. So now that I have a flywheel holder with means to turn the crank I figured I might as well pull the valve covers and readjust the rockers. only issue is when I use the mark on the harmonic balancer as a reference to adjust the valves as it says in my lt1 rebuilding manual the intake valve in cylinder number 1 is still partially open when my manual says to make sure they are both closed. Is is possible the harmonic balancer was pressed on crooked when the engine was built? I'm kind of at a loss here. Any ideas?

c4boom 04-21-2011 09:00 PM

you sure you are not 360 out

black heartbeat 04-21-2011 09:41 PM

^^^when I do that the intake isn't quite closed yet. I'm thinking just do each cylinder individually

84ta406 04-22-2011 12:33 AM

Do each one by one following the firing order. Jiggle the crank right and left and make sure the lifters dont move, that means youre on the base circle. If they move its not on the base circle of the cam.

When the balancer says TDC, it could be TDC for #1 or #6.

black heartbeat 04-22-2011 09:20 PM

thanks man I'll give it a shot

84ta406 04-23-2011 05:51 AM

If you need any help feel free to give me a call. My number is in the mantown.

ILuvPizzaTimes10 04-24-2011 12:39 PM

there is no top dead center on the balancer on and LT1 and if there is dont trust it as there is NO key way to align the balancer. it just bolts straight on and were ever it lands it lands.

84ta406 04-24-2011 05:02 PM

Ok even still you can follow my method and jiggle the balancer each direction and make sure neither of the lifters move. It doesnt need to be at TDC to do preload, just on the base circle of the cam.

jayws6 04-24-2011 09:01 PM

here you go

http://shbox.com/1/how_tos.html click adjust valves they have pics too

black heartbeat 04-25-2011 02:44 AM

I'm going to take another shot at this when it stops raining and i get my valve cover back. I'll just move it till i have both the lifters on base circle, theres no need to make this more complicated than it needs to be. Thanks for the help guys


All times are GMT. The time now is 09:07 AM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.