Wire mod and TC relocation
 

Finally got around to eliminating that stupid wiring harness on the passenger strut tower. And relocated the TC module to behind the pcm. After I was done I sanded/primed/painted/cleared the strut tower. Came out pretty good overall. I did the other side too but I still have some wiring over there that I dont really want to get into moving around but it came out pretty good too. Sorry for the crappy cell phone pic....

http://i56.photobucket.com/albums/g1...04101303a1.jpg

there was enough slack to move the TC all the way back there

looks good nice job

Yeah not too bad to do. There was a step by step write up on ls1tech on how to do it. The TC module just gets unbolted and ziptied behind the pcm. Then you just extend the 2 wires for the connector and run the wiring along with the big harness through a 1 3/4 hole in front of the pcm. The harness then gets wrapped in rubber splicing tape and gets velcroed between the strut tower and inner fender well.

thats sweet! looks good justin

Easier to get rid of the TC.Buy a non-tc cable,throw away TC and the TCS light just stays on-like you pushed the off button.

looks sleek good job

Nice cool to see someone on here do that always read about that on ls1tech write up and wanted to do it to my car (just the wire mod) because I don't have TCS.

Yeah I really should of done it sooner. Now I just need to get this thing back on the road kicking ass!!! LOL.... Should look nice though. Ive done a bunch of other clean up work on the acessories.

Looks good, now get the bitch running again!