Thread
:
soo
View Single Post
#
15
02-07-2011, 01:00 AM
Slowhawk
choking the wrench
Join Date: Oct 2009
Posts: 1,526
Post Thanks / Like
Thanks (Given):
Thanks (Received):
Likes (Given):
Likes (Received):
Dislikes (Given):
Dislikes (Received):
The point of milling heads to raise compression is to get the most out of the setup.Run less compression and make less power across the curve or spend $$ or take time to measure/cut the pistons. It's not a big deal.Takes me less than 2hr's to do.
Slowhawk
View Public Profile
Send a private message to Slowhawk
Find all posts by Slowhawk