^ I have found that the TFS heads flow more at the mid lift numbers. The exhaust flow is up there also compared to the AFR heads. Mid and low lift #'s are where the money is. Such as a set of stock heads that flow maybe 160 cfm at .300" and top out at .600" at 220cfm. If you can get that head to flow more, sooner, you won't have to run a HUGE lift cam. My .640" cam was a bit much for me, but I had to compromise on something. I wanted under 230 duration and around .600", but the reviews on this cam were pretty good. .600" lift, initially, scared me off, then I warmed up to the idea. The MS cams never caught my eye. But the Torquer V2 and 3 were an option when I was buying mine.
And from what I've read, these heads will always outflow the plastic intakes.
I was wanting a set of the TFS heads for a while and asked what heads were recommended and they actually spec'd me a set of AFR 205's. I'll do those eventually and save the TFS idea for an L92/LS3/LS9 clone idea I've been tossing around. And the guy who spec'd my cam has had a setup push 550rw with NA h/c. -Not with my cam, but still. I have an idea how to extract what I'm looking for.
__________________
h/c/i/s/e
|