And one last one... I'm just trying to kill some myths here. I was against this (102) intake from the beginning for the exact reasons that pizza has voiced here, but I have seen a LOT the data and from what I have gathered the 102 is an effective piece. Now I'm going to see what PatG recommends and I will go from there and onto real-world "tests" this spring.
Quote:
|
Originally Posted by Tony Mamo @ AFR
Honestly that's a scary quote....(air "stalling" in the intake runners)
Even at idle you have eight pistons 4" across moving vertically close to the same depth at 6-7 times per second (just counting the "intake stroke" in the four cycle engine, not the power stroke)....trust me there is no air "stalling"....its moving thru that plenum at a pretty good clip (because there are eight cylinders pulling from the plenum) and moving thru the runners at a reasonably brisk pace as well. Start turning some RPM's and look out....you guys would be amazed and how much airflow is really moving thru only a 500 HP engine combination. A 300 CFM intake port @ 28" depression will suck you hand to that head (if you get close enough) with enough force to hurt you and that doesn't even represent whats really going on when an engine is at full song.
The good thing about the Internet is the plethora of information available to digest.....the bad thing about the Internet.....yes you guessed it....the plethora of information available to digest.
You need to be selective about who's theories and opinions you might latch on to....
I have seen so much bad info "parroted" from one source to the next its crazy.....
Always verify the accuracy of the source in question....whether discussing engines or which electric razor might work the best.
I love researching things on the Net but I have a pretty good nose for what info might be accurate and what info might not be....comes with age I think though :lol:
-Tony
|