View Single Post
  #12  
Old 11-19-2009, 02:37 AM
John in RI John in RI is offline
Popped My Cherry
 
Join Date: Nov 2009
Location: Rhode Island
Posts: 52
Post Thanks / Like
Thanks (Given):
Thanks (Received):
Likes (Given):
Likes (Received):
Dislikes (Given):
Dislikes (Received):
Default

Quote:
what am I going to need for the LS1 front brakes? calipers, spindels, rotors, lines and wtf else?
That's pretty much it other than pads/rotors. I recall that the hubs were interchangable and all you had to do was bend the original brake hose brackets to make them work. & be sure to check the ball jionts while your in there !

I can't offer much advise on swapping the rear brakes,..... I'd assume it's just a matter of swapping the backing plates (disk to disk). I swapped to a complete LS1 rear when the 4.11's were installed. +1 on the negative feedback about the LS Disk rear internal parking brake !! I have NEVER been able to get mine set correctly after swapping the rear end !!!

Reply With Quote