[c4boom]

don give me a call I have to jump on some thing. Going to take weeks to get this thing back even if they do warranty it. I have been very polite to them and patient offering any info they requested and photos. I even told them my exact launching and burn out procedure and they said that sounded fine. I torqued it down to there pattern in the torque sequence that they gave me in the intervals listed in the instructions. also cleaned the flanges. I was told by them that I did not have to check the slave depth so I did not. i used red lock tight on the bolts and I adjusted the master so it just had full disengagement about a 1/4 of the stroke from the floor. tick told me with the monster that is how it should be done. I have installed many clutches and this is the first one I have had that went bad I dont know what I could have done differently to prevent what had happened