View Single Post
  #63  
Old 07-22-2011, 03:19 AM
84ta406 84ta406 is offline
Future club Dangle member
 
Join Date: Oct 2009
Location: Worcester, MA
Posts: 1,802
Post Thanks / Like
Thanks (Given):
Thanks (Received):
Likes (Given):
Likes (Received):
Dislikes (Given):
Dislikes (Received):
Default

Well I graduated wyotech top of my class, won some fancy awards as well and earning a few ASE certs. Since I've been home I've been working a shit ton but in my free time I get over to my dads place where the car is and have been wrenching on it.

While porting the heads I managed to go through the pushrod wall due to some really bad core shift in the heads. I ended up drilling out the pushrod tubes to .500 and putting . 014" brass tubes in to seal them.



The port work I've very happy with. I was able to get 280cfm out of them at .600 lift and 200cfm on the exhaust side. Along with new cam and eventually the ported manifold it should deff. make some steam. I only went out to a Fel-pro 1205 gasket too, leaving a lot of room for a 1206 to gain more flow. All this through a set of 2.02/ 1.6 valves on a 4.000" fixture.

End product so far..



__________________
5.3L LSx, Fbody .500 cam, TH400, 4500 Stall, Moser 9"
Reply With Quote