View Single Post
  #34  
Old 08-29-2011, 01:22 AM
Camaro9969's Avatar
Camaro9969 Camaro9969 is offline
Camaro SS480
 
Join Date: May 2011
Location: Agawam Ma
Posts: 834
Post Thanks / Like
Thanks (Given):
Thanks (Received):
Likes (Given):
Likes (Received):
Dislikes (Given):
Dislikes (Received):
Default

Quote:
Originally Posted by SLP IROC-Z View Post
ok just watchd the videos, back in the water and do a quick dump in 2nd to get them wet, pull up out of the water box and do a 2nd gear burnout at 5000 to 5500 rpms for a good 5 seconds then ride it out for a few feet. doing the burnout in the water poses two problems, the tires not drying off completely and the shock load from spinning the tires on wet ground and then hitting dry sticky concrete, this is a sure fired way to grenade a 10 bolt.

i can tell youre shifting way to early just from where you are on the track when you shift.
watch me race the gtp in the end of this video http://youtu.be/oLfJipqLlsI
my engine is 100% stock, and i shift just shy of my 6200 limiter, pay close attention to where each of my shift points are on the track. youre shifting 1-2 right at the 60' mark, thats way before 6k rpm. not only will that hurt your 60' but its going to slow your runs way down. im running a stock tach and no shift light, but after hitting the rev limiter a few times before a shift i got an idea of where my rpms were and were to shift the car at. with a 6500rpm shift point you should be over 100' out before youre into 2nd gear.
Thanks for the help man ill do that. Holy shit u run a 12.7? You pulled a wheel off the ground!!!! That's a strong rear end lol nice work Hope to get better times because I know its got it and the weather will be much better Wednesday night
__________________

1999 Camaro SS480
http://www.youtube.com/watch?v=hGXXuq9T2TI
G,M. Precision Welding and Fabrication
GMPrecisionWelding@gmail.com
Reply With Quote