Thread: Rear LCA tight access to front chassis bolt
View Single Post
  #1  
Old 08-20-2012, 09:14 PM
BryanH BryanH is offline
over 125 posts and less than 12.5 seconds
  
Join Date: Oct 2009
Posts: 162
Post Thanks / Like
Thanks (Given):
Thanks (Received):
Likes (Given):
Likes (Received):
Dislikes (Given):
Dislikes (Received):
Default Rear LCA tight access to front chassis bolt
What do you guys use to torque down your front bolt/nut on the rear LCA's? This is the chassis side. Lots of install docs recommend 80 ft/lbs on both sides.. nut and bolt. I can't figure out how to get my torque wrench in on either side. My LCAs are on tight.. just not torqued.

These are dual rod end LCA's by the way.
Reply With Quote