Thread: 799 heads/cam ?
View Single Post
  #19  
Old 01-18-2013, 05:59 AM
84ta406 84ta406 is offline
Future club Dangle member
 
Join Date: Oct 2009
Location: Worcester, MA
Posts: 1,802
Post Thanks / Like
Thanks (Given):
Thanks (Received):
Likes (Given):
Likes (Received):
Dislikes (Given):
Dislikes (Received):
Default

Got a TH400 and cooler for sale haha..

In all seriousness its not hard to take the heads apart and use some sand cartridges to atleast clean up the castings. I did this on a set of iron heads and pickeup clost to 15cfm per intake port and a bit less on the exhaust side. Well worth the few hour to clean em up and make them run just a little better than someone elses.

I do agree with doing a cam only. Heads are a PITA and if its only a small gain like Don said.. deff. Not worth it.
__________________
5.3L LSx, Fbody .500 cam, TH400, 4500 Stall, Moser 9"
Reply With Quote