Go Back   North East F-Body Association > Tech > LT1/TPI/TBI

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 10-25-2010, 05:48 AM
bottledbird68 bottledbird68 is offline
Build,beat,break,repeat..
 
Join Date: Jan 2010
Location: Athol MA
Posts: 1,980
Post Thanks / Like
Thanks (Given): 8
Thanks (Received): 19
Likes (Given): 27
Likes (Received): 74
Dislikes (Given): 12
Dislikes (Received): 4
Default

Quote:
Originally Posted by 84ta406 View Post
"get a 94-95 PCM, the part number ends in 8051. It plugs right into the same engine harness and will run the engine just fine. If you want the knock sensors to function, you need to spend 4 minutes with a soldering iron and a $1 resistor, or I'll do it for you, you just need to connect pins 21 and 22 in the blue connector on the 94-95 PCM to each other, then connect that to ground through a 2K ohm resistor...I THINK pin 1 is ground...but if it's not, there's a ground plane on the circuit board right next to the pins...96-97 LT1 is by far THE EASIEST to convert to OBD1...and the OBD1 LT1 PCM is better supported both with datalogging software and tuning software than the 96-97.

Since it's not in an OBD2 car if you swap it, you shouldn't even think twice...OBD2 cars have to have OBD2 PCM's...3rd gen's don't."

Thats exactly what he said.

Cant wait to go home and start pulling apart the caprice now! No rush on the ecu since I'm still in school down in PA. Should I bother with the knock sensor?
Well ok then just remind me from time to time before you come back up to go dig
__________________
The fleet...
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 07:16 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.