Getting to Starter Wiring

[ILuvPizzaTimes10]

i dont know how your k-member/framing is setup on an RX7 but i usually drop the starter(battery disconnected) and pull wires off after its loose from the engine and i can swing it around.

[sciff5]

Originally Posted by ILuvPizzaTimes10

i dont know how your k-member/framing is setup on an RX7 but i usually drop the starter(battery disconnected) and pull wires off after its loose from the engine and i can swing it around.

Hmm didnt really think of that.. I may just pull the headers or the starter. I wanted to see if anyone had any tips or tricks I was thinking I may have enough length in the harness that I can pull the engine out of the engine bay a couple feet and get in there with a wrench