Differnt tips on the TA?

[941LE]

i wonder if the 2 tail pipes themselves would be able to slide over the outlets on the magnaflow muffler?

[black heartbeat]

Originally Posted by 941LE

i wonder if the 2 tail pipes themselves would be able to slide over the outlets on the magnaflow muffler?

If they were expanded males they should

[ILuvPizzaTimes10]

oooo expanded males?!?!?! were do i get one?!?!?!?

to put new tips on the magna crap muffler setup your going to need either new mandrel tail pipes and cut the ones off close to the muffler. thats if you want to save the magnaflow ones. or you can cut the tips off the pipes and then have to weld a small section of pipe to the existing tail pipe and then add the tip. all in all i hate magnaflow.

[Batman]

Originally Posted by frankzlt1

Here are some crappy pis of a slp muffler I have. You could cut off the tips to make it work for you.

Dude I don't even have an Fbody right now and I will buy that dual/dual off of you, if you cut it I say instant ban FOR LIFE!

[frankzlt1]

Originally Posted by Batman

Dude I don't even have an Fbody right now and I will buy that dual/dual off of you, if you cut it I say instant ban FOR LIFE!

I wasn't going to cut the tips off, I just put this out there for 94le because he's looking for new tips. I don't want the muffler it was on my car when I got it and I also was given the original dual out same side and that muffler sounds a hell a lot better.

[Formula413]

That's the 2 out the left (2OTL for short), very highly sought after. I've only seen one, on an LT1 Firehawk.

[jayws6]

I have been looking to change my tips

lolllolol

[KLAB]

Originally Posted by ILuvPizzaTimes10

to put new tips on the magna crap muffler setup your going to need either new mandrel tail pipes and cut the ones off close to the muffler. thats if you want to save the magnaflow ones. or you can cut the tips off the pipes and then have to weld a small section of pipe to the existing tail pipe and then add the tip. all in all i hate magnaflow.

Thats what I did with my CME tips. I cut the cannon tips off the tail pipes that come out of the muffler. Its the only way ypou will get straight lined up tips off that muffler because the two bends are different. Actually they wont line up to begin with because both me and boomers setups have mis-aligned tips out of the box rofl. But my CME is welded to my MegaBlow.

[KLAB]

ps I think the 2OTL Is dumb idk why its so sought after, sure the rarity factor? But who the hell wants two tips only on one side? Might as well have a JDM fartcan single exhaust of just one pipe...

[irockidz28]

Originally Posted by KLAB

ps I think the 2OTL Is dumb idk why its so sought after, sure the rarity factor? But who the hell wants two tips only on one side? Might as well have a JDM fartcan single exhaust of just one pipe...

x2